Power Windows do not Operate Using All Window Switch [11/2015 - ]: Procedure

1. Disconnect the J1 power window regulator master switch assembly connector.
2. Measure the voltage and resistance according to the value(s) in the table below.

   Standard Voltage

   W/ REAR POWER WINDOW
   
   

   Tester Connection	Condition	Specified Condition
   J1-6 (B) - Body ground	Ignition switch ON (IG)	11 to 14 V

   W/O REAR POWER WINDOW
   
   

   Tester Connection	Condition	Specified Condition
   J1-15 (B) - Body ground	Ignition switch ON (IG)	11 to 14 V

   Standard Resistance

   W/ REAR POWER WINDOW
   
   

   Tester Connection	Condition	Specified Condition
   J1-1 (E) - Body ground	Always	Below 1 Ω

   W/O REAR POWER WINDOW
   
   

   Tester Connection	Condition	Specified Condition
   J1-7 (E) - Body ground	Always	Below 1 Ω

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  2

1. Replace the power window regulator master switch assembly (Refer to REMOVAL [11/2015 - ] ).

NEXT 

See step  3

1. Check the power windows operation by using the power window regulator master switch assembly and power window regulator switch assemblies.

   OK

   All power windows operate normally.

Result: 

OK 

END (POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WAS DEFECTIVE) 

Result: 

NG 

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) 

Refer to REMOVAL [11/2015 - ] )