Installation [08/2015 - ]: Procedure

1. Install the sensor clamp with the nut (labeled A).

   Torque: 15 N*m (153 kgf*cm, 11 ft.*lbf) 

   NOTE:

   Make sure the clamp's rotation stopper touches the installation position.

2. Install the sensor clamp with the bolt (labeled B).

   Torque: 13 N*m (127 kgf*cm, 9 ft.*lbf) 

   NOTE:

   When installing the clamp, do not twist the wire harness.

3. Attach the 7 clips (labeled C).
   NOTE:

   • When installing the clamps, do not twist the wire harness.
   • When installing the clamps, securely insert them as shown in the illustration.
4. Connect the sensor connector (labeled D).
   NOTE:

   Securely connect the connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Install the speed sensor (labeled A) with the nut (labeled B).

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Torque: 11 N*m (107 kgf*cm, 8 ft.*lbf) 

2. Connect the speed sensor connector (labeled C).
   NOTE:

   Securely connect the connector.

1. Install the speed sensor (labeled A) with the nut (labeled B).

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Torque: 11 N*m (107 kgf*cm, 8 ft.*lbf) 

2. Connect the speed sensor connector (labeled C).
   NOTE:

   Securely connect the connector.

for Aluminum Wheel 

Torque: 131 N*m (1336 kgf*cm, 97 ft.*lbf) 

for Steel Wheel 

Torque: 209 N*m (2131 kgf*cm, 154 ft.*lbf) 

1. Check the speed sensor signal (Refer to TEST MODE PROCEDURE [08/2015 - 08/2017] , or refer to TEST MODE PROCEDURE [08/2017 - ] ).