FixVault
Home › Toyota › 2019 › Tundra TRD Pro › Repair and Diagnosis › Brakes › Traction Control › Brake Control / Dynamic Control Systems (Service Information) › Steering Angle Sensor › Removal [08/2015 - ] › Procedure

Removal [08/2015 - ]: Procedure

  1. PRECAUTION 
    NOTE:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Refer to PRECAUTION [08/2015 - 08/2017] , or refer to PRECAUTION [08/2017 - 08/2019] , or refer to PRECAUTION [08/2019 - ] ).

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    WARNING:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

  3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD 
  4. REMOVE LOWER NO. 3 STEERING WHEEL COVER 

    Refer to PROCEDURE - Step 3 [08/2015 - 08/2017], or refer to PROCEDURE - Step 3 [08/2017 - ]

  5. REMOVE LOWER NO. 2 STEERING WHEEL COVER 

    Refer to PROCEDURE - Step 4 [08/2015 - 08/2017], or refer to PROCEDURE - Step 4 [08/2017 - ]

  6. REMOVE STEERING PAD 

    Refer to PROCEDURE - Step 5 [08/2015 - 08/2017], or refer to PROCEDURE - Step 5 [08/2017 - ]

  7. REMOVE STEERING WHEEL ASSEMBLY 

    Refer to PROCEDURE - Step 7 [08/2015 - 08/2017], or refer to PROCEDURE - Step 7 [08/2017 - ]

  8. REMOVE LOWER STEERING COLUMN COVER 

    Refer to PROCEDURE - Step 8 [08/2015 - 08/2017], or refer to PROCEDURE - Step 8 [08/2017 - ]

  9. REMOVE UPPER STEERING COLUMN COVER 

    Refer to PROCEDURE - Step 9 [08/2015 - 08/2017], or refer to PROCEDURE - Step 9 [08/2017 - ]

  10. REMOVE SPIRAL CABLE SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 10

  11. REMOVE STEERING ANGLE SENSOR 

    Refer to PROCEDURE - Step 10

About FixVault