FixVault
Home › Toyota › 2019 › Tundra TRD Pro › Repair and Diagnosis › Brakes › Traction Control › Brake Control / Dynamic Control Systems (Service Information) › Trailer Brake Control Ecu › Installation [08/2017 - ] › Procedure

Installation [08/2017 - ]: Procedure

  1. INSTALL TRAILER BRAKE CONTROL ECU (BRAKE CONTROL WITH BRACKET RELAY) 
    1. Connect the 2 connectors to the trailer brake control ECU (brake control with bracket relay).
    2. install the trailer brake control ECU (brake control with bracket relay) with the 2 nuts.

      Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf) 

  2. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY 

    Refer to PROCEDURE - Step 3

  3. INSTALL LOWER INSTRUMENT PANEL 

    Refer to PROCEDURE - Step 20 [08/2017 - 08/2019], or refer to PROCEDURE - Step 21 [08/2019 - ]

  4. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 21 [08/2017 - 08/2019], or refer to PROCEDURE - Step 22 [08/2019 - ]

  5. INSTALL INSTRUMENT SIDE PANEL RH 

    Refer to PROCEDURE - Step 17 [08/2017 - 08/2019], or refer to PROCEDURE - Step 18 [08/2019 - ]

  6. INSTALL COWL SIDE TRIM BOARD RH 

    Refer to PROCEDURE - Step 30 [08/2017 - 08/2018], or refer to PROCEDURE - Step 32 [08/2018 - 08/2019], or refer to PROCEDURE - Step 33 [08/2019 - ]

  7. INSTALL FRONT DOOR SCUFF PLATE RH 

    Refer to PROCEDURE - Step 34 [08/2017 - 08/2018], or refer to PROCEDURE - Step 36 [08/2018 - 08/2019], or refer to PROCEDURE - Step 37 [08/2019 - ]

  8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [08/2017 - 08/2019] , or refer to INITIALIZATION [08/2019 - ]

  9. PERFORM DIAGNOSTIC SYSTEM CHECK 

    Refer to DTC CHECK / CLEAR [08/2017 - ]

  10. CHECK SRS WARNING LIGHT 

    Refer to OPERATION CHECK [08/2017 - ]

About FixVault