Inspection [11/2015 - ]: Procedure
- INSPECT KNOCK CONTROL SENSOR
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Click Location & Routing(E1)
Click Connector(E1)
Tester Connection Condition Specified Condition E1-1 - E1-2 20°C (68°F) 120 to 280 kΩ If the result is not as specified, replace the knock control sensor.
*a Component without harness connected
(Knock Control Sensor)
- Measure the resistance according to the value(s) in the table below.