FixVault
Home › Toyota › 2021 › Prius XLE AWD-e › Repair and Diagnosis › Engine Performance › Fuel Delivery › Fuel System - Service Information › Fuel Pump › Inspection [11/2015 - 12/2018] › Procedure

Inspection [11/2015 - 12/2018]: Procedure

  1. INSPECT FUEL PUMP WITH FILTER ASSEMBLY 
    1. Check the resistance.
      GTY702662Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Fuel Pump with Filter Assembly)
      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection Condition Specified Condition
        A-1 - A-2 20°C (68°F) 0.2 to 3.0 Ω

        If the result is not as specified, replace the fuel pump with filter assembly.

    2. Check the operation.
      1. Apply auxiliary battery voltage to both terminals. Check that the fuel pump with filter assembly operates.
        NOTE:
        • Perform this test within 10 seconds to prevent the coil from burning out.
        • Keep the fuel pump with filter assembly as far away from the auxiliary battery as possible.
        • Always switch the voltage on and off at the auxiliary battery side, not the fuel pump with filter assembly side.

        If the fuel pump with filter assembly does not operate, replace the fuel pump with filter assembly.

About FixVault