Inspection [11/2015 - ]: Procedure
- INSPECT AIR FUEL RATIO SENSOR
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(Air Fuel Ratio Sensor)Standard Resistance
Click Location & Routing(C24)
Click Connector(C24)
Tester Connection Condition Specified Condition C24-1 (HA1A) - C24-2 (+B) 20°C (68°F) 1.6 to 3.2 Ω C24-1 (HA1A) - C24-4 (A1A-) Always 10 kΩ or higher If the result is not as specified, replace the air fuel ratio sensor.
- Measure the resistance according to the value(s) in the table below.