Removal [11/2018 - 08/2020]: Procedure

REMOVE STARTER ASSEMBLY
- w/ Stop And Start System:
  Refer to REMOVAL [11/2018 - 02/2019] , or refer to REMOVAL [02/2019 - 08/2020]
- w/o Stop And Start System:
  Refer to REMOVAL [11/2018 - 02/2019] , or refer to REMOVAL [02/2019 - 10/2019] , or refer to REMOVAL [10/2019 - 08/2020]

REMOVE CRANKSHAFT POSITION SENSOR

Disconnect the crankshaft position sensor connector.

GTY944382

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the bolt and crankshaft position sensor from the cylinder block sub-assembly.
NOTE:
If the crankshaft position sensor has been struck or dropped, replace it.

GTY906893

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*1

O-ring

Perform this procedure only when reusing the crankshaft position sensor.

Remove the O-ring from the crankshaft position sensor.
NOTE:
- Make sure to only remove the O-ring with bare hands.
- When removing the O-ring, be careful not to damage the O-ring groove of the crankshaft position sensor.
- If the O-ring groove of the crankshaft position sensor is damaged, replace the crankshaft position sensor with a new one.