Inspection [11/2018 - ]: Procedure
- CHECK INTEGRATION CONTROL & PANEL ASSEMBLY (DOWNHILL ASSIST CONTROL SWITCH)
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(Downhill Assist Control Switch)Standard Resistance
Tester Connection Switch Condition Specified Condition 16 (E) - 19 (B) Switch pushed Below 1 Ω Switch not pushed 10 kΩ or higher HINT:
If the result is not as specified, replace the integration control and panel assembly (downhill assist control switch).
- Measure the resistance according to the value(s) in the table below.