On-Vehicle Inspection [05/2022 - ]: Procedure

HINT: 

Perform "Inspection After Repair" after replacing the intake mass air flow meter sub-assembly.

• for Gasoline Model:

  Refer to INITIALIZATION [11/2021 - ]

• for HEV Model:

  Refer to INITIALIZATION [05/2022 - 08/2024] , or refer to INITIALIZATION [08/2024 - ]

1. Read the value of Data List item "MAF Sensor Bank1 / MAF Sensor Bank2" using the GTS.
   NOTE:

   Perform the inspection of the intake mass air flow meter sub-assembly while it is installed to the air cleaner assembly (installed to the vehicle).

   1. Check and ensure the following conditions:
      1. Turn off all electrical loads, such as the air condition, etc.
      2. Check that the coolant temperature is 75 °C (167 °F) or more.
      3. Put the Shift Lever in the N position.
   2. Start the engine.
   3. According to the display on the GTS, read the Data List when the engine is running.

      Powertrain > Engine > Data List 

      Tester Display
      MAF Sensor Bank1
      MAF Sensor Bank2

      Standard Condition

      GTS Display	Condition	Specified Condition
      MAF Sensor Bank 1 MAF Sensor Bank 2	Idling (engine warmed up and shift state D)	1.8 to 3.0 gm/sec
      	2000 rpm (without load)	5.0 to 25.0 gm/sec
      	3000 rpm (without load)	6.5 to 30.0 gm/sec

      If the result is not as specified, clean (air blow) the intake mass air flow meter sub-assembly.

      After cleaning (air blowing) the intake mass air flow meter sub-assembly, perform an on-vehicle inspection of the intake mass air flow meter sub-assembly again and replace the intake mass air flow meter sub-assembly if the result is not as specified.

      If the result is within the specified range, inspect the intake mass air flow meter sub-assembly.

      Refer to INSPECTION [11/2021 - ] 

1. Remove the air cleaner cap sub-assembly.
2. Clean the intake mass air flow meter sub-assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	Intake Air Flow Meter Sub-assembly
   *a	Air Blow Gun
   *b	10 mm (0.3937 in.)
   *c	Airflow Hole

   NOTE:

   • Do not contact the intake mass air flow meter sub-assembly with the nozzle of the air blow gun.
   • Do not insert the nozzle of the air blow gun into the airflow hole.
   1. Using an air blow gun, clean the hole of the intake mass air flow meter sub-assembly by applying approximately 10 intermittent bursts of air to the airflow hole at a pressure of approximately 392 to 981 kPa (4.0 to 10.0 kgf/cm² , 57 to 142 psi).

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      *a	Air Blow Duration
      *b	3 to 6 seconds
      *c	1 second
      *d	Air Blowing
      *e	Air Stopped

3. Install the air cleaner cap sub-assembly.