Clutch Assembly: Installation

Center clutch disc on flywheel using a suitable alignment tool, then install pressure plate and tighten attaching bolts evenly. To complete installation, reverse removal procedure.

To install, reverse removal procedure and note the following: Ensure index marks on clutch assembly match with those on flywheel. Make sure engine rear stabilizer is properly adjusted. Adjust restraint cable as follows: Loosen front nut at rear of cable, then tighten rear nut to 5-8 ft. lbs. (0.69 - 1.1 mkg) to settle cable into position. Loosen rear nut and holding cable with fingers, position rear nut so a clearance of 0.031 - 0.063" (0.79 - 1.6 mm) clearance exists between cable and bracket, tighten front nut.