Windshield Camera Calibration (Launch Mobile): Notes

Mobile Repair Possible:  No

Required Setup Area: 

Ensure the vehicle is placed in a location with sufficient clear space around the vehicle:

• Front Windshield Camera Calibration - 1 meter either side of the vehicle and 3 meters in front

Workstation and Vehicle Setup Considerations: 

• FLAT and UNIFORM FLOOR SURFACE with sufficient space for the vehicle and equipment at same level
• UNIFORM and BRIGHT ILLUMINATION by a non-frequency flash light source such as:
  • LED Lights
  • Industrial Lighting complying with international standards
  • Dual Light Source in opposite phase
• Light source should ensure NO REFLECTED SPOTS or SHADOWS on calibration targets
• Avoid excessive natural light through windows or door openings
• Avoid changes in brightness such as vehicles driving past with lights on
• Vehicle should be in PARK and "Driver Present" mode (Ignition ON but eMotor OFF)
• Steering Wheel CENTERED pointing straight ahead
• Doors and Hood in CLOSED position
• Mirrors in UNFOLDED position
• All Vehicle Exterior Lights OFF
• Tires INFLATED to specification
• Vehicle wheel alignment within specification

Key Measurements: 

Front windshield camera target pattern boards (LAM01-07-L and LAM01-07-R) must be aligned with vehicle centre line and:

• Positioned 2900 mm forward of the centre line of the front axle.
• Mounted at a height of 1530.4 mm (+/- 10 mm) from the ground to the centre line of the target