U0232 - Lost Communication With Blind Spot Detection Module: Notes
For a complete wiring diagram, refer to appropriate SYSTEM WIRING DIAGRAM.
- >>When Monitored:<< Continuously when the ignition is on. Battery voltage between 10 and 16 volts. Ignition Off Draw (IOD) fuse installed. Totally Integrated Power Module (TIPM) is configured correctly.
- >>Set Condition:<< Bus messages not received from the Blind Spot Detection Module for approximately two to five seconds.
| Possible Causes |
|---|
| CAN B BUS CIRCUITS OPEN OR SHORTED |
| DTCS RELATED TO BATTERY VOLTAGE, IGNITION, OR VIN MESSAGES |
| BLIND SPOT DETECTION MODULE POWER AND GROUND |
| TIPM NOT CONFIGURED CORRECTLY |
| BLIND SPOT DETECTION MODULE |
| MODULE THAT SET THIS DTC |