B1888 - Power Liftgate Pinch Sensor 1 Circuit Low: Notes

For a complete wiring diagram, refer to appropriate Wiring Diagram

• >>When Monitored:<< Whenever the power liftgate module is awake.
• >>Set Condition:<< The power liftgate module has detected the left liftgate pinch sensor circuit voltage is under 0.5 volts for over 20 seconds.

Possible Causes
Q75 LEFT PINCH SENSOR SIGNAL CIRCUIT SHORT TO GROUND
Q75 LEFT PINCH SENSOR SIGNAL CIRCUIT SHORT to Q901 LOGIC GROUND CIRCUIT
LEFT LIFTGATE PINCH SENSOR
POWER LIFTGATE MODULE

Test Step 1 - DTC Present

• With the scan tool, record DTCs and any liftgate inhibitors.
• Erase DTCs.
• Turn the ignition OFF, wait 10 seconds, then turn the ignition ON.
• Operate the liftgate several times.
• With the scan tool, check for DTCs.

Does the scan tool display B1888 - Power Liftgate Pinch Sensor 1 Circuit Low?

Yes

• Go to Test Step 2 Test Step 2 - Left Pinch Sensor Short 

No

• Using the wiring diagram/schematic as a guide, inspect the wiring and connectors for an intermittent condition.
• Perform the Body Verification Test. Refer to BODY VERIFICATION TEST .