B1892 - Power Liftgate Control Circuit 2 High: Notes

For a complete wiring diagram, refer to appropriate Wiring Diagram

• >>When Monitored:<< Whenever the power liftgate is power opening or power closing.
• >>Set Condition:<< When the power liftgate module senses voltage more than 5.5 volts on the liftgate close driver circuit for over 10 seconds, this code will set.

Possible Causes
Q89 LIFTGATE CLOSE DRIVER CIRCUIT SHORT TO VOLTAGE
Q88 LIFTGATE OPEN DRIVER CIRCUIT SHORT TO VOLTAGE
Q88 LIFTGATE OPEN DRIVER CIRCUIT SHORT to Q89 LIFTGATE CLOSE DRIVER CIRCUIT
POWER LIFTGATE MODULE

Test Step 1 - DTC Present

• With the scan tool, record DTCs.
• Erase DTCs.
• Turn the ignition OFF, wait 10 seconds, then turn the ignition ON.
• If possible, operate the liftgate several times.
• With the scan tool, check for DTCs.

Does the scan tool display B1892 - Power Liftgate Control Circuit 2 High?

Yes

• Go to Test Step 2 Test Step 2 - Liftgate Close Driver Circuit Short to Voltage 

No

• Using the wiring diagram/schematic as a guide, inspect the wiring and connectors for an intermittent condition.
• Perform the Body Verification Test. Refer to BODY VERIFICATION TEST .