Test Step 4 - Position Sensor Supply Circuit Open

Fig 1: Position Sensor Supply Circuit Open

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

• Turn the ignition OFF.
• Disconnect the power liftgate module C1 harness connector.
• Measure the resistance of the position sensor supply circuit between the power liftgate module C1 harness connector and the power liftgate drive unit harness connector.

Is the resistance less than 5.0 ohms?

Yes

• Replace the power liftgate module. Refer to POWER LIFTGATE CONTROL MODULE .
• Perform the Body Verification Test. Refer to BODY VERIFICATION TEST .

No

• Repair the position sensor supply circuit for an open.
• Perform the Body Verification Test. Refer to BODY VERIFICATION TEST .