11.2 Peripheral Camera Control Module - J928-, Removing And Installing

Removing 

• Raise the front seat into its highest position and then move it all the way back.
• Turn off the ignition and all electrical equipment.
• Move the ignition key outside of the vehicle to prevent switching on the ignition unintentionally.
• Remove the expanding rivets -arrows-.
• Push the cover -1- with the Peripheral Camera Control Module - J928-, straight in the direction of travel, while paying attention to the connected wires and turn.
• Release and disconnect the connectors -3-.
• Release the catches on the cover -1- in the direction of the -arrow-.
• At the same time remove the Peripheral Camera Control Module - J928- -2- from the cover -1-.

Installing 

Install in reverse order of removal and note the following:

• Calibrate the peripheral camera. Refer to 11.7 Peripheral Camera, Calibrating