Chip Card Reader Control Module, Removing And Installing: Notes
WARNING: This page is about a different car, the 2025 Audi S3, 2025 Audi RS 3, and 2025 Audi A3 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
The Chip Card Reader Control Module -J676- is located in the glove compartment, only for Japan (ER5).
If the Chip Card Reader Control Module - J676- is replaced, the following procedure applies:
-- Connecting and switching on the Vehicle Diagnostic Tester.
-- Switch the ignition on.
-- Select and start the Diagnostic operating mode.
-- Select the Test plan tab.
-- Select the Select individual test button and select the following tree structure consecutively:
- Diagnostic-capable systems
- 005F - Information Electronics Control Module 1 - J794 (MIB 3)
- 005F - Information Electronics Control Module 1, functions
- 0642 - Chip Card Reader Control Module -J676 replacing
-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.