Peripheral Camera System, Calibrating

WARNING: This page is about a different car, the 2022 Volkswagen ID.4 and 2021 Volkswagen ID.4. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Calibration System: VAS721001

Preparing

Requirement

Refer to Necessity of Calibration .
There may be no DTC memory entry present because they prevent the calibration.

Overview of the Installed Calibration System VAS721001

Fig 1: Overview of the Installed Calibration System: VAS721001

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Left Calibration Field from the Calibration System: VAS721001
Front Peripheral Camera -R243-
Right Calibration Field from the Calibration System: VAS721001
Right Peripheral Camera -R245-
Rear Peripheral Camera -R246-
Left Peripheral Camera -R244-

-- Check the camera images on the display unit.

-- Check the cameras, brackets, and retainers for damage, external influences, and secure fit.

-- Check and clear the DTC memory using the Vehicle Diagnostic Tester.

-- Roll out the calibration fields to the left and right side, close to the vehicle.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Requirement

The arrows -1- must point in the direction of travel.

-- Install the end strips at the front and rear of the calibration fields.

-- Align the calibration fields to the left and right side, close to the vehicle.

Requirement

On both sides of the vehicle the crosshair -2- must be aligned centered to the front wheel.
The dimension -a- 2000 mm to 2500 mm ± 5 mm, must be the same at the front and rear.
The dimension -b- must be the same on both sides.
The dimension -c- must be the same on both sides.

Calibrating

Requirement

Vehicle Diagnostic Tester connected.

-- Perform the "Peripheral Camera System, Calibrating" function using the Vehicle Diagnostic Tester. Refer to DIAGNOSTIC ENTRIES .