Transmission - Installation (644 Body)
- Transmission
- Nut on the transmission oil return line for oil pipe bracket
- Transmission fluid, replacing (AW55-50)
- Transmission, installing (M56; turbocharged engines)
- Notes
- Cleaning and lubricating the input shaft
- Checking before installing
- Install the transmission
- Raise the engine/transmission to the horizontal position.
- Install the mounting on the transmission
- Install the brackets in the gearcase
- Install the right driveshaft.
- Install the support member under the engine.
- Fit the left-hand drive shaft
- Checking the left-hand side drive shaft
- Tighten the wheel spindle/spring strut nuts/screws to 90 Nm
- Attach the hose to the intercooler/charge air pipe
- Check the transmission fluid level. Install the protective plate and wheels.
- Attach the pipe to the branching and bracket. Install the branching clip.
- Attach and tighten the hose clip and retaining clamp to the charge air pipe.
- Install the engine compartment components
- Transmission, installing (M56; B4204S2)
- Notes
- Cleaning and lubricating the input shaft
- Checking before installing
- Transmission, installing
- Raise the engine/transmission to the horizontal position.
- Mount the transmission mounting on the transmission and body
- Mounting brackets in the gearcase, installing
- Drive shaft right-hand side, installing
- Longitudinal member, installing
- Front exhaust pipe, installing
- Transverse support member, installing
- Drive shaft left-hand side, installing
- Drive shaft left-hand side, checking
- Tighten the wheel spindle/spring strut nuts/screws to 90 Nm.
- Check and fill transmission fluid
- Protective covers and wheels, installing
- Attach the connecting pipe to the branching and bracket
- Flywheel sensor, installing
- Gear selector cables and clips on the transmission, installing
- Connect the transmission ground connection.
- Engine compartment components, installing
- Air intake hose
- Transmission, installing (AW55-50/51SN)
- Notes
- Checking before installing
- Adjust the position of the engine / transmission
- Install and tighten the screws for the transmission
- Install the torque converter screws
- Install the collision protection system over the steering gear (right-hand drive cars)
- Install the sub-frame components
- Lift up the engine and transmission to the horizontal position
- Install the rear engine mounting
- Install the sub-frame on the bodywork
- Install the left drive shaft on the transmission, the wheel spindle and the control arm
- Install the right drive shaft in the transmission, the wheel spindle and the control arm
- Install and tighten the sub-frame screws
- Install the oil pipe on the transmission
- Install and tighten the suspension components (both sides)
- Tighten the ball joint pinion
- Install new lock nuts on the steering gear
- Tighten the screw for the rear engine pad
- Reinstall the exhaust pipe
- Install the exhaust pipe on the turbocharger (TC)
- Install the screws for the bracket for the heated oxygen sensor (HO2S) cable
- Reinstall the front cross member
- Install the screw for the front engine pad and the torque rod mounting in the sub-frame
- Install the screw for the ground lead and the cable conduit
- Lower the car. Remove the lifting beam from the engine
- Install the remaining screws for the transmission and starter motor
- Install the dip stick pipe and the ground lead on the transmission
- Install the transmission cable on the transmission and the lever
- Install the charge air pipe on the charge air cooler (CAC). Connect the upper oil hose to the oil cooler
- Install the air cleaner (ACL) and the upper torque rod in the engine compartment
- Finishing work