Checking brake light switch adjustment: Notes

Fig 1: Identifying Ignition ON

GLL101051

Courtesy of VOLVO CARS OF NORTH AMERICA.

VIDA connected to the vehicle.
Start the engine.
Activate readout of components by clicking on the symbol for VCT2000.

Slowly press down the brake pedal.

Check the pedal position sensor's value when the brake light switch status changes from Off to On .

The pedal position sensor shall have a value of at least 0.8 mm when the brake light switch status changes from Off to On .

If the pedal position sensor's value is below the value given above, the brake light switch shall be readjusted.

Other information
- To adjust the brake light switch, see Stop lamp switch, replacing .
Fig 2: Identifying VCT2000 Diagnostic Tool Symbol In VIDA
Courtesy of VOLVO CARS OF NORTH AMERICA.

Continue
OKAY: Troubleshooting has been completed.
Refer to Communication fault