Carrier Plate - Removal And Installation
- Engine Mechanical
- Replacing the carrier plate
- Notes
- Removal
- Installation
- Removing the transmission
- Notes
- Disconnecting the battery lead
- Removing engine compartment components
- Removing the upper torque rod
- Continue removing engine compartment components
- Removing the torque control arm
- Removing the transmission cable from the lever and the screws for the cable bracket on the transmission
- Removing the mounting screws for the transmission / starter motor
- Installing the lifting hook, part 1
- Installing the lifting hook, part 2
- Installing the lifting beam and lifting hook on the engine
- Removing the air baffle and splash guard under the engine
- Draining the transmission fluid
- Removing the nuts and screws for the steering gear sub-frame
- Hanging up the steering gear in a tie strap. Use the hole in the body
- Removing the screws for the cable conduit and ground lead bracket on the sub-frame
- Removing the nut for the lower ball joint / control arm
- Removing the control arms and tie rod (both sides)
- Removing the screws from the sub-frame support plates (both sides)
- Removing the wheel spindle from the control arm
- Removing the drive shaft from the wheel spindle (right-hand side)
- Removing the cap for the drive shaft support bearing
- Removing the drive shaft
- Press up the sub-frame on the right-hand side
- Removing the charge air pipe for the turbocharger (TC) under the engine
- Removing the screws for the torque rod from the transmission
- Removing the screw from the starter motor and the exhaust pipe from the turbocharger (TC)
- Removing the front cross member
- Removing the screw for the rear engine pad
- Removing the rear engine mounting
- Preparatory work for removing the wheel spindle on the left-hand side
- Removing the left drive shaft from the transmission
- Lowering the sub-frame
- Lowering the engine and transmission
- Removing the collision protection system over the steering gear
- Removing the 6 screws for the torque converter
- Removing the screw for the transmission / engine
- Preparations for removal of the transmission
- Installing the fixture on the mobile jack and the transmission
- Removing the transmission
- Check
- Replacing the carrier plate