Transmission Sensors - Removal And Installation
- Transmission
- Temperature sensor, transmission fluid, replacing
- Transmission input speed sensor, replacing
- Transmission output speed sensor, replacing (AW50-42)
- Transmission output speed sensor, replacing (AW55-50)
- Notes
- Preparations
- Removing the air cleaner (ACL) housing and intake manifold
- Disassembling the connector for the transmission output speed sensor. Removing the sensor
- Lubricating the O ring for the new transmission output speed sensor. Installing the sensor
- Installing the air cleaner (ACL) housing and intake manifold
- Checking diagnostic trouble codes (DTCs)
- Transmission, installation
- Notes
- Cleaning and lubricating the input shaft
- Checking before installing
- Adjusting the position of the transmission and engine
- Installing and tightening screws for the transmission
- Lifting the engine and transmission to the horizontal position
- Installing the rear engine mounting
- Installing the bevel gear
- Installing the front propeller shaft (Applies to AWD)
- Installation of the collision protection above the steering gear (Only applies to right-hand drive vehicles.)
- Fitting the sub-frame to the body
- Installing the sealing ring for the CV joint housing
- Installing the left hand drive shaft to the transmission, wheel spindle and link arm
- Installing new lock nuts and screws on the steering gear
- Installing the screw in the rear engine pad
- Installing screws for the bracket for the heated oxygen sensor (HO2S) wiring
- Installing the crossmembers
- Installing the right-hand drive shaft to the gearbox, wheel spindle and link arm
- Installing the screw for the front engine pad and the torque rod mounting in the transmission
- Installing and tightening front suspension components
- Tightening the ball joint pinion
- Installing the nuts on the fender liner
- Checking the oil level in the transmission
- Installing the screws for the transmission and engine
- Installing the pipe junction
- Installing the bracket and lever for the transmission
- Installing the water hose
- Installing the upper torque rod
- Transmission oil level, checking