PCM (Customer Supplied Only One Valid Key)
WARNING: This page does not describe the selected car, but rather 126 other vehicles, including the 1999 Volvo V70, 1999 Volvo S80, 1999 Volvo S70, 1999 Volvo C70, and 1999 Volkswagen Passat. However, it is still accessible from the selected car via links, so may be relevant.
- Cut new transponder equipped key(s), if necessary. Replace PCM. Using new 1st key, turn ignition to ON position. SECURITY light should illuminate for 1-2 seconds. Turn new 1st key to LOCK position.
- Using new 2nd key, turn ignition to ON position, then LOCK position 6 times. Ensure 6th turning is done within one second. SECURITY light should be flashing at a 300 millisecond interval. Wait about 5 minutes until SECURITY light flashing has decreased to a 1.2 second interval.
- Input code word. See INPUTTING CODE WORD. SECURITY light should stop flashing and stay illuminated. Using new 2nd key, turn ignition to ON position. SECURITY light should illuminate for 1-2 seconds. Turn new 2nd key to LOCK position and remove key.
- Using valid key, start engine. SECURITY light should illuminate for 1-2 seconds and engine should continue to run. Turn valid key to LOCK position and remove key.
- Repeat step 4) with each new key, up to 8 keys total. Wait 30 seconds, program will quit automatically. After reprogramming is complete, clear DTCs with New Generation Star (NGS) tester.
NOTE:
Keys may be new or valid. If errors occur during reprogramming in steps 1) or 2), start over from step 1). If errors occur during step 3), go to REPROGRAM ERROR RECOVERY.