Transmission - Checking & Inspection

• Transmission
  • Checking internal components of the transmission
    • Checking shift solenoids
      • Checking shift solenoids
      • Checking the line pressure solenoid SLT, SLC1, SLC2, SLC3, SLB1 and Lock-up solenoid SLU
      • Checking the oil temperature sensor
    • Checking the input and output speed sensors for the transmission
      • Checking the input and output speed sensors for the transmission
  • Checking pressure and temperature sensor
    • Checking pressure and temperature sensor
  • Checking the oil level (AW50/51 AWD; AW55-50/51SN; 2001-2007)
    • Notes
    • Conditions
      • Conditions
      • Preparing to check the oil level
      • Move the gear selector through all positions. Wait in each position for approximately 3 seconds
    • Low level (topping up)
      • Top up with oil through the dipstick pipe
    • High level (overfilling)
      • Notes
      • Drain off oil
  • Checking wiring and terminals. Intermittent faults
    • Inspect terminals visually
    • Open-circuit, intermittent faults
    • Short-circuit to ground, intermittent faults
    • Short-circuit to supply voltage, intermittent faults
    • Loose connections (terminals)
    • Contact resistance and oxidation
  • Checking wiring and terminals. Permanent fault
    • Check terminals visually
    • Open-circuit, permanent faults
    • Short-circuit to ground, permanent faults
    • Short-circuit to supply voltage. Permanent faults
    • Contact resistance and oxidation
  • Clutch slave cylinder
    • Notes
    • Removal
      • Removing the gearbox
      • Removing the clutch cylinder
      • Checking the clutch cylinder and the throw-out bearing
    • Installation
      • Notes
      • Installing the clutch cylinder
      • Finishing