Transmission - Adjustments, Cleaning And Inspection
- Adjustments
- Adjusting transmission cable
- Cleaning and inspection
- Connecting Volvo Scan Tool (ST)
- Connector A terminal (No. 1-90)
- Control module connector (No. 1-42)
- Diagnostics/check list
- Gearbox, removing
- Notes
- Filling in Diagnostic and Check lists
- Disconnecting battery lead
- Removing engine compartment components
- Removing dipstick
- Removing gear selector cable from lever and mounting on gearbox
- Removing mounting screws from gearbox/starter motor
- Removing right screw from gearbox
- Installing lifting beam and lifting hook on engine lifting eyelet
- Removing splash guards
- Removing screws for cable conduit and ground lead bracket on sub-frame
- Removing nut for lower ball joint/control arm
- Remove control arms, track rod and spring strut on both sides
- Removing screws for sub-frame support plates (both sides)
- Removing stub axle from control arm
- Removing drive shaft from stub axle (right-hand side)
- Removing cap for drive shaft support bearing
- Removing drive shaft
- Press up sub-frame on right-hand side
- Removing nuts and screws for steering gear sub-frame
- Removing screws for torque rod from gearbox
- Removing exhaust pipe from turbocharger (TC)
- Removing front cross member
- Removing bracket for cable for heated oxygen sensor (HO2S) from sub-frame
- Removing exhaust pipe mounting in rear cross member
- Removing screw for rear engine pad
- Removing rear engine mounting
- Preparations for removing stub axle on left-hand side
- Removing left drive shaft from gearbox
- Lowering sub-frame
- Removing lower oil pipe from gearbox
- Removing collision protection system over steering gear
- Lowering engine and gearbox
- Removing 6 screws for torque converter, and 7 screws for gearbox/engine
- Preparations when removing gearbox
- Installing fixture on mobile jack and gearbox
- Removing all 7 screws for gearbox/engine
- Removing gearbox
- Cleaning and checking
- Upper torque rod