Transferring Components

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2014 Volvo XC90, 2013 Volvo XC90, 2012 Volvo XC90, 2011 Volvo XC90, and 2010 Volvo XC90. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Sub-Frame Components

Courtesy of VOLVO CARS CORPORATION

Transfer

the control arms. Use new screws and new nut. Tighten the front screws. Tighten to 65 Nm . Angle-tighten 90° . Use bevel protractor see 9512050 . Tighten the rear screw. Tighten to 105 Nm . Angle-tighten 90°
the anti-roll bar. Tighten to 60 Nm
the right-hand engine mounting. Tighten the screws. Tighten to 65 Nm . Angle-tighten 60°
the mounting for the heated oxygen sensor (HO2S) wiring
the engine pad.

Install new pipe / hose holders.