Calibrating The Position Sensor In The Control Module

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Ignition ON

GLL101051

Courtesy of VOLVO CARS CORPORATION

Ignition on
Place the gear selector lever in neutral position (N).
Activate calibration of the position sensor in the transmission control module (TCM) by clicking on the VCT2000 symbol in VIDA (Volvo scan tool).

CAUTION:
During calibration, it is important that no diagnostic trouble codes (DTCs) for the gear selector module (GSM) are stored and that the gear selector assembly is otherwise free of faults.

Fig 2: Identifying VCT2000 Diagnostic Tool Symbol In VIDA
Courtesy of VOLVO CARS CORPORATION

Fig 3: Identifying Control Module/Gear-Shift Position Sensor
Courtesy of VOLVO CARS CORPORATION

Continue
Refer to READING OFF DIAGNOSTIC TROUBLE CODES (DTCS)