Checking The Control Module
- Ignition off
- Transmission control module (TCM) connected
- The breakout box connected
- Transmission connector disconnected
- Connect a temporary cable between terminals #A35 and #A59 on the breakout box
- Ignition on
- Read off the status.
Check that the status is "1" when the temporary cable is connected to the terminals above.
Disconnect the cable end that is connected to terminal #A35 and move the cable to terminal #A53.
NOTE:Leave the cable end connected to terminal #A59 in place.
Check that the status changes to "0" when the temporary cable has been moved to terminal #A53.
The transmission output speed sensor is defective if the status has changed between "1" and "0" as above and no errors have been detected on the cables or terminals in the preceding checks. Replace the transmission output speed sensor.
The transmission control module (TCM) is defective if the status has not changed between "1" and "0" as above and no errors have been detected on the cables or terminals in the preceding checks. If this is the case replace the control module.
Remedy as necessary.
Other information
- To connect the breakout box, see CONNECTING THE BREAKOUT BOX
- To disconnect the transmission connector, see CONNECTING THE BREAKOUT BOX, GM AUTOMATIC TRANSMISSIONS
- To check or replace the transmission output speed sensor, see OUTPUT SPEED SENSOR TRANSMISSION, REPLACING
- To replace the transmission control module (TCM), see TRANSMISSION CONTROL MODULE (TCM), REPLACING
- For information about signals, see SIGNAL SPECIFICATION .
Check that the temporary cable is connected to the correct terminals. Also check that there is no risk of unintentional short-circuits.
Was a fault detected?
- YES
Refer to VERIFICATION
- NO
Refer to CHECKING THE WIRING AND COMPONENT