Overview - Selector Mechanism

Fig 1: Identifying Selector Mechanism Overview

Courtesy of AUDI OF AMERICA, LLC

O-Ring
- Replacing
Selector Lever Cable
- Do not bend
- Removing and installing, refer to OVERVIEW - SELECTOR LEVER CABLE .
Bolt
- For selector lever cable adjustment
- Tightening specification -item 3-.
Transmission Park Selector Switch -F305-
- Consists of two micro-switches on the circuit board on the Shift Lock Solenoid - N110-.
- Can only be replaced together with the Shift Lock Solenoid -N110-, refer to Shift Lock Solenoid -N110-, REMOVING AND INSTALLING .
Shift Lock Solenoid -N110-
- Removing and installing, refer to Shift Lock Solenoid -N110-, REMOVING AND INSTALLING .
Cover
- via the Shift Lock Solenoid -N110-
Selector Lever Sensor System Control Module -J587- with Tiptronic Switch -F189-
- Removing and installing, refer to Selector Lever Sensor System Control Module -J587-, REMOVING AND INSTALLING .
Nut
- 8 Nm
- for securing the shift mechanism to the body
- Quantity: 4
Seal
Selector Mechanism Function Unit
- Can only be replaced as a unit
- Removing and installing, refer to SELECTOR MECHANISM, REMOVING AND INSTALLING .
  - Perform "Guided Functions" using the Vehicle Diagnostic Tester after removing and installing the selector mechanism function unit, refer to TRANSMISSION GUIDED FUNCTIONS .
Clip
- For selector lever cable
Noise Insulation
- Not installed on all vehicles
- Allocation.
Lock washers
- For the noise insulation
- Quantity: 4
- Replacing