High Pressure Test
WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 1995 BMW 540i, 1995 BMW 530iT, 1995 BMW 530i, 1995 BMW 525i, and 1994 BMW 540i. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Test must be carried out with the engine switched off.
- Unscrew one bleeder screw, connect pressure tester and bleed. See Figure .
- Load brake pedal with a force of 110 lbs. (500 N) and block brake pedal with support. After 2 minutes, pressure must not drop by more than 8 percent.
- Repeat procedure on other circuit.
- Complete low pressure test. See LOW PRESSURE TEST .