Circuit/System Testing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
When removing connectors inspect for damage or corrosion. Damage or corrosion in the following requires repair or replacement of the affected component/connector.
- The vehicle rollover sensor
- The SDM module
- The vehicle rollover sensor harness connector
- The SDM wiring harness connector
- For DTC B0090 39 replace the vehicle rollover sensor.
- For DTC B0090 0F, B0090 3A and B0090 71 request DTC from ROS and repair any ROS DTC prior to continuing this diagnostic procedure.
- With Ignition OFF, disconnect the vehicle rollover sensor connector. Refer toInflatable Restraint Vehicle Rollover Sensor Replacement in repair instructions for connector location.
- Remove the SDM connector. Refer to SDM Replacement in repair instructions for connector location.
- Test the vehicle rollover sensor serial data circuit for an open or high resistance between the vehicle rollover sensor and SDM connector. Verify no open or high resistance exists.
- If any of the above conditions are found make the appropriate repair.
- Test the vehicle rollover sensor ignition 1 voltage circuit for a short to ground, a high resistance, or an open. Verify no short to ground, a high resistance, or an open exists.
- If any of the above conditions are found make the appropriate repair.
- Replace the inflatable restraint vehicle rollover sensor. Perform the Inflatable Restraint Vehicle Rollover Sensor Programming and Setup procedure.
- Ignition ON, use the scan tool to clear the DTCs, then recheck for DTC B0090. Verify that the DTC does not reset.
- If DTC B0090 was current replace the SDM.