FixVault
Home › Chevrolet › 2006 › Impala SS › Repair and Diagnosis › External Pages › Different variant/trim › Section 6 (Engine Control System - 3.9L - Introduction (2 Of 2)) › Repair Instructions › Fuel Level Sensor Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Slide The Fuel Level Sensor Onto The Bucket And Upward
    GM1575967Courtesy of GENERAL MOTORS CORP.
  1. Slide the fuel level sensor (1) onto the bucket and upward.
    2. Fig 2: Slide The Fuel Level Sensor Upward Until The Retainer Locks
    GM1575966Courtesy of GENERAL MOTORS CORP.
  2. Slide the fuel level sensor upward until the retainer (1) locks.
    3. Fig 3: Connect The Fuel Level Sensor Electrical Connector
    GM1575965Courtesy of GENERAL MOTORS CORP.
  3. Connect the fuel level sensor electrical connector (1).
  4. Install the fuel tank module. Refer to Fuel Tank Module Replacement .
About FixVault