FixVault
Home › Chevrolet › 2009 › Impala SS › Repair and Diagnosis › External Pages › Different car › Section 1612 (Supplemental Inflatable Restraint System) › Repair Instructions › Inflatable Restraint Side Impact Module Wiring Harness Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2012 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    WARNING:

    Refer to SIR Inflator Module Handling and Storage Warning .

    WARNING:

    Refer to SIR Warning .

  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
    2. Fig 1: Identifying Side Impact Module Wiring Harness
    GM1506504Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Removal of the right or the left inflatable restraint side impact module wiring harness uses the same procedure.

  2. Remove the inflatable restraint side impact module from the seat. Refer to Driver or Passenger Seat Side Inflatable Restraint Module Replacement .

    With the seat back panel removed, the inflatable restraint side impact module wiring harness (1) will be exposed.

  3. Remove the clips that fasten the side impact module wiring harness (1) to the seat.
About FixVault