Removal Procedure
- Drain the cooling system. Refer to Drive Motor Generator Power Inverter Module Cooling System Draining and Filling
- Remove the front wheelhouse front liner on the driver and passenger side. Refer to Front Wheelhouse Front Liner Replacement
- Remove the front bumber fascia. Refer to Front Bumper Fascia Removal and Installation
- Unfasten and reposition the drive motor battery coolant pump with out draining the battery cooling system. Refer to Drive Motor Battery Coolant Pump Replacement
- Unbolt and reposition the drive motor battery coolant cooler outlet hose Refer to Drive Motor Battery Coolant Cooler Outlet Hose Replacement
- Unbolt and reposition the drive motor battery coolant inlet hose. Refer to Drive Motor Battery Coolant Inlet Hose Replacement
- Remove the drive motor generator control module cooling outlet hose clamp (1) at generator control module coolant pump using BO-38185 Hose Clamp Pliers.
- Remove the drive motor generator control module cooling outlet hose (2) from the generator control module coolant pump.
- Remove the drive motor generator control module cooling outlet hose clamp (1) at drive motor battery charger using BO-38185 Hose Clamp Pliers.
- Remove the drive motor generator control module cooling outlet hose (2) from drive motor battery charger.
- Disconnect the drive motor generator control module cooling outlet hose (1) from the cooling fan and shroud.
- Remove the drive motor generator control module cooling outlet hose from the vehicle.
NOTE:
Replace corroded hose clamps and brackets.