FixVault
Home › Chevrolet › 2016 › Spark EV › Repair and Diagnosis › Hybrid/Electric Powertrain › Battery Management Systems › Hybrid/EV Energy Storage System › Repair Instructions › Battery Energy Control Module Replacement › Installation Procedure

Installation Procedure

    Fig 1: Battery Energy Control Module And Fasteners
    GM3712206Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  1. Install the battery energy control module (2) to the mounting studs and tighten the fasteners (1) to 9 N.m (80 lb in).
    2. Fig 2: Battery Energy Control Module Connectors (With Connection Sequence)
    GM4072893Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Damage to the battery energy control module may occur if connector sequence to the module is not followed.

  2. Connect the battery energy control module connectors in the sequence shown to the battery energy control module.
    3. Fig 3: Battery Energy Control Module Connectors (With Connection Sequence)
    GM4072895Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Damage to the battery energy control module may occur if connector sequence to the module is not followed.

  3. Connect the battery energy control module connectors in the sequence shown to the battery energy control module.
    4. Fig 4: Harness Retainers
    GM4072896Courtesy of GENERAL MOTORS COMPANY
  4. Connect the harness retainers (1) to the battery energy control module bracket.
  5. Install the drive motor battery cover. Refer to Drive Motor Battery Cover Replacement .
  6. Install the drive motor battery. Refer to Drive Motor Battery Replacement and Shipping Preparation .
About FixVault