Removal & Installation
WARNING: This page is about a different car, the 1997 Mercury Mountaineer, 1997 Ford Explorer, and 1996 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect negative battery cable. ABS control module is located in engine compartment, on left front inner fender panel behind plastic fender liner. Disconnect 40-pin connector from ABS control module. Raise and support vehicle.
- Remove left front wheel. Remove left front fender apron. Remove mounting screws and remove ABS control module. To install, reverse removal procedure. Tighten screws to specification. See TORQUE SPECIFICATIONS .