VSA Modulator-Control Unit Removal and Installation: Installation
- Install the VSA modulator-control unit on the bracket with three 6 mm bolts.
- Install the VSA modulator-control unit/bracket on the body, then tighten the three 6 mm nuts.
- Reconnect the six brake lines, then tighten the flare nuts.
- Align the connecting surface of the VSA control unit 47P connector.
- Carefully push in the lock of the VSA control unit 47P connector until you hear it click into place, then confirm the connector is fully seated.
- Bleed the brake system, starting with the front wheels (see BRAKE SYSTEM BLEEDING ).
- Do VSA sensor neutral position memorization (see VSA SENSOR NEUTRAL POSITION MEMORIZATION ).
- Start the engine, and check that the ABS and VSA indicators go off.
- Test-drive the vehicle, and check that the ABS and VSA indicators do not come on.