FixVault
Home › Lexus › 2007 › GS 350 RWD › Repair and Diagnosis › External Pages › Different variant/trim › Section 2 (Transfer Case) › Transfer Valve Body Assembly › Installation

Transfer Valve Body Assembly: Installation

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL TRANSFER CONTROL SOLENOID (See  REASSEMBLY  ) 
  2. INSTALL TRANSFER VALVE BODY ASSEMBLY 
    1. Connect the transfer wire connector to the transfer control solenoid.
    2. Install the transfer upper valve body with the 4 bolts.
      Fig 1: Locating Bolts And Transfer Upper Valve Body
      G05295959Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf) 

  3. INSTALL TRANSFER OIL PAN (See  INSTALLATION  ) 
  4. INSTALL TRANSFER DYNAMIC DAMPER (See  INSTALLATION  ) 
  5. INSTALL ENGINE REAR MOUNTING MEMBER (See  INSTALLATION  ) 
  6. INSTALL FRONT EXHAUST PIPE ASSEMBLY 

    (See INSTALLATION )

  7. ADD AUTOMATIC TRANSMISSION FLUID (See  COMPONENTS  ) 
  8. CHECK FOR EXHAUST GAS LEAKS 
About FixVault