FixVault
Home › Lexus › 2007 › GS 430 › Repair and Diagnosis › Electrical › Starter › Starting (3UZ-FE) › Engine Switch › Installation

Engine Switch: Installation

  1. INSTALL ENGINE SWITCH 
    1. Attach the 2 claws and install the switch.
      Fig 1: Locating Engine Switch Claws
      G05287836Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Connect the switch connector.
  2. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY (See  INSTALLATION  ) 
  3. INSTALL INSTRUMENT PANEL NO. 1 UNDER COVER SUB-ASSEMBLY (See  INSTALLATION  ) 
  4. INSTALL INSTRUMENT PANEL NO. 1 SAFETY PAD SUB-ASSEMBLY (See  INSTALLATION  ) 
  5. INSTALL INSTRUMENT SIDE PANEL LH (See  INSTALLATION  ) 
  6. INSTALL FRONT DOOR OPENING TRIM COVER LH (See  INSTALLATION  ) 
  7. INSTALL FRONT DOOR SCUFF PLATE LH (See  INSTALLATION  ) 
  8. INSTALL INSTRUMENT PANEL FINISH PANEL END LH (See  INSTALLATION  ) 
  9. INSTALL FRONT CONSOLE UPPER PANEL ASSEMBLY (See  INSTALLATION  ) 
  10. INSTALL FRONT CONSOLE UPPER PANEL GARNISH (See  INSTALLATION  ) 
  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  12. PERFORM INITIALIZATION 
    1. Perform initialization (see INITIALIZATION ).
      NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
  13. CHECK SRS WARNING LIGHT 
    1. Check the SRS warning light (see DIAGNOSIS SYSTEM ).
About FixVault