Park / Neutral Position Switch: Installation

INSTALL NEUTRAL START SWITCH ASSEMBLY
1. Install the park/neutral position switch to the manual valve shaft.
2. Temporarily install the bolt.
  
  Fig 1: Locating Park/Neutral Position Switch Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install a new lock washer with the lock nut.
  Torque: 6.9 N*m (70 kgf*cm, 61 in.*lbf)
  
  Fig 2: Locating Lock Washer With Lock Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Turn the control shaft lever counterclockwise until it stops, and turn it clockwise 2 notches to set it to the neutral position.
5. Remove the transmission control shaft lever.
  
  Fig 3: Positioning Transmission Control Shaft
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Align the neutral basic line with the switch groove, and tighten the bolt.
  Torque: 13 N*m (133 kgf*cm, 10 ft.*lbf)
  
  Fig 4: Aligning Neutral Basic Line With Switch Groove
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
7. Using a screwdriver, bend the tabs of the lock washer.
  
  Fig 5: Bending Tabs Of Lock Washer
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
8. Connect the neutral start switch connector to the neutral start switch.
INSTALL ENGINE REAR MOUNTING MEMBER (See INSTALLATION )
INSTALL FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY (See INSTALLATION )
INSTALL PROPELLER W/CENTER BEARING SHAFT ASSEMBLY
(See REMOVAL )

Fig 6: Locating Neutral Start Switch Connector
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
INSPECT NEUTRAL START SWITCH ASSEMBLY (See INSPECTION )
ADJUST SHIFT LEVER POSITION (See ADJUSTMENT )
INSPECT SHIFT LEVER POSITION (See INSPECTION )
INSTALL FRONT FLOOR HEAT INSULATOR NO.1 (See INSTALLATION )
INSTALL EXHAUST PIPE NO.1 SUPPORT BRACKET SUB-ASSEMBLY (See INSTALLATION )
INSTALL FRONT EXHAUST PIPE ASSEMBLY
(See INSTALLATION )
CHECK FOR EXHAUST GAS LEAKS
PERFORM INITIALIZATION
(See INITIALIZATION )