Anti-Lock - Traction Control & Stability Assist
- Specifications
- Description And Operation
- Diagnosis And Testing
- Anti-Lock Control-Traction Control and Stability Assist
- Notes
- Principles of Operation
- Inspection and Verification
- Stability Assist Module Diagnostic Trouble Code (DTC) Index
- Stability Assist Module Parameter Identification (PID) Index
- Stability Assist Module Active Command Index
- Stability Assist Calibration List
- Symptom Chart
- Pinpoint Test A: No Communication With The Stability Assist Module
- Pinpoint Test B: DTC B1485 - Brake Pedal Input Circuit Battery Short
- Pinpoint Test C: DTC B1676 - Battery Pack Voltage Out Of Range
- Pinpoint Test D: DTC C1095 - ABS Hydraulic Pump Motor Circuit Failure
- Pinpoint Test E: DTC C1145 (RF), DTC C1155 (LF), DTC C1165 (RR), DTC C1175 (LR) Anti-Lock Brake Sensor Input Circuit Failure
- Pinpoint Test F: DTC C1233 (LF), DTC C1234 (RF), DTC C1235 (RR), DTC C1236 (LR) - Anti-Lock Brake Sensor Input Signal Missing
- Pinpoint Test G: DTC C1277 - Steering Wheel Angle 1 And 2 Circuit Failure, DTC C1278 - Steering Wheel Angle 1 And 2 Circuit Faulted
- Pinpoint Test H: DTC C1279 - Yaw Rate Sensor Circuit Failure, DTC C1280 - Yaw Rate Sensor Signal Fault
- Pinpoint Test I: DTC C1281 - Lateral Accelerometer Circuit Failure, DTC C1282 - Lateral Accelerometer Signal Fault
- Pinpoint Test J: DTC C1285 - Brake Booster Solenoid Output Failure
- Pinpoint Test K: DTC C1286 - Booster Mechanical Failure
- Pinpoint Test L: DTC C1287 - Booster Pedal Force Switch Circuit Failure
- Pinpoint Test M: DTC C1288 - Pressure Transducer Main/Primary Input Circuit Failure
- Pinpoint Test N: DTC C1289 - Pressure Transducer Redundant/Secondary Input Circuit Failure
- Pinpoint Test O: DTC C1730 - Reference Voltage Out Of Range (+5 V)
- Pinpoint Test P: DTC C1960 - Driver Brake Apply Circuit Fault
- Pinpoint Test Q: The Yellow ABS Warning Indicator Does Not Self-Check
- Pinpoint Test R: The Traction Control Is Inoperative
- Pinpoint Test S: The Stability Assist/Traction Control Switch Indicator Is Never/Always On
- Pinpoint Test T: The Stability Assist System Cannot Be Disabled
- Pinpoint Test U: The Stability Assist Indicator Does Not Self-Check
- Anti-Lock Control-Traction Control and Stability Assist
- Removal And Installation