| 1 |
REPLACE PCM
Refer to PCM removal/installation to perform PCM replacement and configuration. (See PCM REMOVAL/INSTALLATION [L3 WITH TC]
.) (See PCM CONFIGURATION [L3 WITH TC]
.) |
Go to the next step. |
| 2 |
PERFORM PARAMETER RESET
- Connect the M-MDS to the DLC-2. (See M-MDS Connecting Procedure .)
- Turn the ignition switch to the ON position using a valid key or valid card key.
NOTE:
Although the security light remains illuminated and DTC 23 is displayed after approx. 1 min.
continue to perform the procedure as indicated.
- Verify that the keyless warning light illuminates for approx. 3 s
and then turns off.
- After vehicle identification, select the following from the M-MDS initial screen.
- Using an IDS (laptop PC)
- Select the "Body"
- Select the "Security"
- Select the "PATS function"
- Using a PDS (Pocket PC)
- Select the "Programming"
- Select the "PATS function"
- Select "Parameter Reset" from the M-MDS screen menu.
- Perform the security access according to the directions on the M-MDS screen. (See SECURITY ACCESS PROCEDURE .)
- Select the replaced parts "PCM" according to the directions on the M-MDS screen.
CAUTION:
At this time, do not select the other parts from the M-MDS menu.
- After verifying that the PATS function menu is displayed again on the M-MDS screen, select "Finish (this menu)".
- Turn the ignition switch to the LOCK position.
- Turn the ignition switch to the ON position.
- Verify that the security light illuminates for approx. 3 s
and then turns off.
- Turn the ignition switch to the LOCK position.
|
Go to the next step. |
| 3 |
VERIFY PROGRAMMING IS PERFORMED CORRECTLY
- Verify that the engine can be started with all the keys.
- Can the engine be started?
|
Yes |
Procedure is completed |
| No |
Perform the corresponding DTC inspection to repair the malfunction part. |