Oil Pressure Switch Inspection
WARNING:
- A hot engine can cause severe burns. Turn off the engine and wait until it is cool before removing the exhaust system.
- Disconnect the negative battery cable.
- Remove the aerodynamic undercover. (See AERODYNAMIC UNDER COVER REMOVAL/INSTALLATION .)
- Remove the oil pressure switch. (See OIL PRESSURE SWITCH REMOVAL .)
- Apply air pressure of approx. 40 kPa {0.41 kgf/cm2 , 5.8 psi} to the oil pressure switch as shown in the figure.
- Measure continuity between oil pressure switch terminal A and the thread area.
- If there is any malfunction, replace the oil pressure switch.
OIL PRESSURE SWITCH CONTINUITYMeasurement condition Continuity Air pressure applied No Air pressure not applied Yes