FixVault
Home › Mazda › 2012 › 6 i Touring Plus › Repair and Diagnosis › Electrical › Horns › Instrumentation/Driver Info › Info Switch Inspection

Info Switch Inspection

  1. Disconnect the negative battery cable.
  2. Remove the following parts:
    1. Front scuff plate (Driver side) (See FRONT SCUFF PLATE REMOVAL/INSTALLATION .)
    2. Front side trim (Driver side) (See FRONT SIDE TRIM REMOVAL/INSTALLATION .)
    3. Upper panel (See UPPER PANEL REMOVAL/INSTALLATION .)
    4. Decoration panel (Driver side) (See DECORATION PANEL REMOVAL/INSTALLATION .)
    5. Hood release lever (See HOOD LATCH AND RELEASE LEVER REMOVAL/INSTALLATION .)
    6. Meter hood (See METER HOOD REMOVAL/INSTALLATION .)
    7. Lower panel (Driver side) (See LOWER PANEL REMOVAL/INSTALLATION .)
    8. INFO switch (See INFO SWITCH REMOVAL/INSTALLATION .)
  3. Verify that the continuity between the INFO switch terminals is as indicated in the table.
    Fig 1: INFO Switch Circuit
    G08145074
    • If not as indicated in the table, replace the INFO switch.
      Fig 2: INFO Switch Terminal Continuity Chart
      G08145075
  4. Apply battery positive voltage to INFO switch terminal E, and connect terminal A to ground.
  5. Verify that the LED illuminates.
    • If there is any malfunction, replace the INFO switch.
About FixVault