FixVault
Home › Mazda › 2017 › 5 GS, Automatic Trans › Repair and Diagnosis › Body & Frame › Door Locks › Security And Locks › Immobilizer System-Related Parts Programming › No. 5 Programming Procedure Due to Instrument Cluster Replacement › Procedure

No. 5 Programming Procedure Due to Instrument Cluster Replacement: Procedure

G13728222Courtesy of MAZDA MOTORS CORP.
NO. 5 PROGRAMMING PROCEDURE DUE TO INSTRUMENT CLUSTER REPLACEMENT

Step Procedure Action after procedure
1 REPLACE INSTRUMENT CLUSTER
Refer to INSTRUMENT CLUSTER REMOVAL/INSTALLATION to perform instrument cluster replacement and configuration.
(See INSTRUMENT CLUSTER REMOVAL/INSTALLATION .)		 Go to the next step.
2 PERFORM PARAMETER RESET
  1. Connect the M-MDS (IDS) to the DLC-2. (See M-MDS (IDS) CONNECTING PROCEDURE .)
  2. Switch the ignition ON using a valid key.
    NOTE:
    • Although the security indicator light starts flashing and DTC 15 is displayed after approx. 1 min, this does not indicate an improper procedure. Continue to perform the procedure as indicated.
  3. After vehicle identification, select the following from the M-MDS initial screen.
  • Using an IDS (laptop PC):
  1. "Body"
  2. "Security"
  3. "PATS (immobilizer) function"
  4. Then, select "Parameter Reset" from the screen menu.
  5. Perform the security access according to the directions on the M-MDS (IDS) screen.
  6. Select the replaced parts "IC" according to the directions on the M-MDS (IDS) screen.
    CAUTION:
    • At this time, do not select the other parts from the M-MDS (IDS) menu.
  7. Verify that the PATS function menu is displayed again on the M-MDS (IDS) screen.
 Go to the next step.
3 PERFORM KEY ID NUMBER CLEARING
  1. Then, select the "Auxiliary Key Program/Clear" from the screen menu.
  2. Clear the key ID number according to the directions on the M-MDS (IDS).
 Go to the next step.
4 PERFORM KEY ID NUMBER PROGRAMMING
  1. Program two keys according to the directions on the M-MDS (IDS).
  2. After verifying that the PATS function menu is displayed again on the M-MDS (IDS) screen, select "Finish (this menu)".
  3. Switch the ignition OFF (LOCK).
  4. Disconnect the M-MDS (IDS) from the DLC-2.
 Go to the next step.
5 VERIFY PROGRAMMING IS PERFORMED CORRECTLY
  1. Verify that the engine can be started with all the keys for approx. 5 s or more.
  2. Can the engine be started?
    NOTE:
    • When verifying that the engine starts, wait approx. 5 s or more before starting the engine using the next key.
 Yes Procedure is completed.
No Perform the corresponding DTC inspection to repair the malfunctioning part.
About FixVault