FixVault
Home › Mazda › 2021 › CX-3 AWD › Repair and Diagnosis › Heating, Ventilation & A/C (HVAC) › HVAC Control Systems › Basic System › Rear Heat Duct Removal/Installation › Driver-side

Rear Heat Duct Removal/Installation: Driver-side

  1. Slide the front seat rearward.
  2. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION .)
  3. Remove the following parts:
    1. Driver-side front scuff plate (See FRONT SCUFF PLATE REMOVAL/INSTALLATION .)
    2. Driver-side front side trim (See FRONT SIDE TRIM REMOVAL/INSTALLATION .)
    3. Driver-side side wall (See SIDE WALL REMOVAL/INSTALLATION .)
    4. Joint cover (See STEERING WHEEL AND COLUMN REMOVAL/INSTALLATION .)
    5. Accelerator pedal (See ACCELERATOR PEDAL REMOVAL/INSTALLATION .)
  4. Remove the fastener.
    G11431329Courtesy of MAZDA MOTORS CORP.
  5. Turn the floor covering over.
  6. Remove the fastener.
    G11431330Courtesy of MAZDA MOTORS CORP.
  7. Remove the rear heat duct.
  8. Install in the reverse order of removal.
About FixVault