Rear Blower Motor Inspection

Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
Remove the following parts:
1. Selector lever knob (See AUTOMATIC TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION .)
2. Shift panel (See SHIFT PANEL REMOVAL/INSTALLATION .)
3. Console side panel (See CONSOLE SIDE PANEL REMOVAL/INSTALLATION .)
4. Front console (See FRONT CONSOLE REMOVAL/INSTALLATION .)
5. Side wall (See SIDE WALL REMOVAL/INSTALLATION .)
6. Rear console (See REAR CONSOLE REMOVAL/INSTALLATION .)
7. Selector lever component (See AUTOMATIC TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION .)
8. Selector lever bracket (See AUTOMATIC TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION .)
Remove the rear blower motor. (See REAR BLOWER MOTOR REMOVAL/INSTALLATION .)
Connect battery positive voltage to blower motor terminal B, connect terminal A to ground, and then verify its operation.

Courtesy of MAZDA MOTORS CORP.
- If there is any malfunction, replace the rear blower motor. (See REAR BLOWER MOTOR REMOVAL/INSTALLATION .)