Section 3773 (Front Axle - Repair (ACTIVEHYBRID))
WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
- General
- 31 00... Front axle + steering: wheel/chassis alignment check must be carried out after the following work
- 31 00... Instructions (chassis components made of aluminium)
- 31 00 Mobile table lift
- 31 00... Notes on repairing threads
- 00..... Raising vehicle with trolley jack
- 00 Safety information for working on vehicles with automatic engine start-stop function (MSA)
- Front Axle Suspension
- Front Sub-Frame
- Struts With Rubber Mounts
- 31 12 003 Removing and installing/replacing top right wishbone
- 31 12 004 Removing and installing/renewing left or right lower control arm
- 31 12 043 Removing and installing/replacing complete front left or right spring strut holder
- 31 12 050 Removing and installing/replacing left or right trailing link
- 31 12 002 Removing and installing/replacing top left wishbone
- 31 12 134 Replacing rubber mount in left or right trailing link
- 31 12 007 Replacing rubber mounts for front axle support in both lower wishbones
- 31 12 008 Replacing rubber mounts for spring strut holder in both lower wishbones
- 31 12 138 Replacing rubber mounts on both trailing links
- Wheel Bearings And Stub Axle
- Spring Strut
- Spring With Suspension
- Stabilizer Bar
- Front Axle Gearbox
- Differential With Bearings
- Output Shaft
- 31 60... Notes on removing and installing Low Profile band clamps
- 31 60... Pressing output shaft out of drive flange (wheel hub) and drawing in
- 31 60 003 Removing and installing/replacing left output shaft
- 31 60 004 Removing and installing/replacing right output shaft
- 31 60 530 Replacing an output shaft gaiter (on transmission side) (output shaft removed)
- 31 60 535 Replacing two gaiters on output shaft(s) (output shaft(s) removed)