General Specifications
WARNING: This page is about a different variant/trim than selected.
Identifying General Specifications (1 Of 2)
| ITEM | SPECIFICATION | ||
|---|---|---|---|
| REAR AXLE | |||
| Wheel bearing | Type | Unit ball bearing (Double-row angular contact ball bearing) | |
| Drive shaft Joint | Type | Outer | EBJ |
| Inner | TJ | ||
| Length (joint to joint) x diameter mm (in) | Left | 485.6 x 25 (19.1 x 1.0) | |
| Right | 575.5 x 25 (22.7 x 1.0) | ||
Identifying General Specifications (2 Of 2)
| ITEM | SPECIFICATION | ||
|---|---|---|---|
| DIFFERENTIAL | |||
| Reduction gear type | Hypoid gear | ||
| Reduction ratio | 3.307 | ||
| Differential gear type (Type x number of gears) | Side gear | Straight bevel gear x 2 | |
| Pinion gear | Straight bevel gear x 4 | ||
| Number of teeth | Drive gear | 43 | |
| Drive pinion | 13 | ||
| Bearings (Outside diameter x Inside diameter) mm (in) | Side | 72.0 x 25.0 (2.83 x 1.0) | |
| Front | 62.0 x 25.0 (2.44 x 1.0) | ||
| Rear | 72.0 x 25.0 (2.83 x 1.0) | ||
NOTE:
The wheel bearing is part of the hub, therefore its size is not listed here.